基于八面体理论的岩石循环加-卸载本构模型及修正

探究岩石的受力特点及破坏特性是研究岩石地下工程安全性的关键,诸多学者都期望能在岩石本构模型的研究上取得突破性进展。在此背景下,提出了一种能够描述循环加-卸载条件下岩石的本构模型。首先,假设岩石的微元强度服从八面体剪应力理论并且微元破坏服从Weibull概率公式,将岩石本构中的损伤变量以及岩石微元强度表达式里包含的损伤因子进行本构变换,得到关于应力、应变等其他表现加-卸载下岩石损伤本构模型的参数,表示出岩石微元强度和损伤变量,再将得到的岩石微元强度和损伤变量代入所提出的岩石本构模型中,并进行等式变换得到一个函数表达式。通过将其与实验数据进行拟合对比分析,得出修正后的拟合参数,将其代入函数式中,得到损伤本构模型的修正式。最后将拟合参数进行必要的敏感性分析,得出各拟合参数的实际物理意义。     

一种超导重力仪磁悬浮力的等效计算

为实现超导重力仪磁悬浮力的精确计算,以GWR型超导重力仪为模型基础,采用有限元的思想,将超导球表面电流理想化为多个等高共轴电流环,计算出各个电流环与超导线圈的作用力,求和得到线圈与超导球间的磁悬浮力。利用MATLAB完成计算程序实现,通过改变下线圈电流和上、下线圈电流比,获得满足一定条件的磁悬浮力及其梯度。选取合适的模型参数,计算出线圈对质量为m=4.069 g超导球的磁悬浮力大小为:Ftotal=3.988×10^-2N,磁悬浮力梯度为:-9.699×10^-3N/m,此时悬浮力梯度合适,满足系统稳定性和灵敏度的要求。     

White and some colored marbles as alternative radiation shielding materials for applications

ABSTRACT

In this paper, the radiation shielding parameters such as linear attenuation coefficients (LAC, µ), mass attenuation coefficients (MAC, µ/ρ), effective atomic numbers (Z_eff), effective electron densities (N_eff), half value of layers (HVL), mean free paths (MFP) and buildup factors (exposure (EBF) and energy absorption (EABF)) were investigated for cream (M1), pink (M2), white (M3), maroon (M4) and green (M5) marbles. Attenuation coefficients were measured in the energy region 31.18–661.66 keV photon energies. The values of Z_eff and N_eff were then calculated using these coefficients with logarithmic interpolation method, and HVLs and MFPs were calculated using the values of LAC of marble samples at the same photon energies. The experimental results were compared with the theoretical values obtained from WinXCom program, and good agreements were observed between the experimental and theoretical results. HVLs and MFPs of all marble samples were compared with those of some concretes, glasses and commercial radiation shielding glasses (SCHOTT Co.). The studied marbles were better radiation shielding materials than standard shielding concretes due to lower HVL and MFP values lower than the ordinary concrete. Finally, EBFs and EABFs of the marbles were calculated in the energy region 0.015–1?MeV up to penetration depths of 40 mfps by Geometric Progression method (G-P), and the results were discussed in terms of photon energies and chemical compositions of the marbles.     

Engineering nanostructures of CuO-based photocatalysts for water treatment: Current progress and future challenges

Nowadays, increasing extortions regarding environmental problems and energy scarcity have stuck the development and endurance of human society. The issue of inorganic and organic pollutants that exist in water from agricultural, domestic, and industrial activities has directed the development of advanced technologies to address the challenges of water scarcity efficiently. To solve this major issue, various scientists and researchers are looking for novel and effective technologies that can efficiently remove pollutants from wastewater. Nanoscale metal oxide materials have been proposed due to their distinctive size, physical and chemical properties along with promising applications. Cupric Oxide (CuO) is one of the most commonly used benchmark photocatalysts in photodegradation owing to the fact that they are cost-effective, non-toxic, and more efficient in absorption across a significant fraction of solar spectrum. In this review, we have summarized synthetic strategies of CuO fabrication, modification methods with applications for water treatment purposes. Moreover, an elaborative discussion on feasible strategies includes; binary and ternary heterojunction formation, Z-scheme based photocatalytic system, incorporation of rare earth/transition metal ions as dopants, and carbonaceous materials serving as a support system. The mechanistic insight inferring photo-induced charge separation and transfer, the functional reactive radical species involved in a photocatalytic reaction, have been successfully featured and examined. Finally, a conclusive remark regarding current studies and unresolved challenges related to CuO are put forth for future perspectives.     

Numerical approach for the evolution of spin-boson systems and its application to the Buck–Sukumar model

We study the evolution properties of spin-boson systems by a systematic numerical iteration approach, which performs well in the whole coupling regime. This approach evaluates a set of coefficients in the formal expression of the time-dependent Schr?dinger equation by expanding the initial state in Fock space. This set of coefficients is unique for the spin-boson Hamiltonian studied, allowing one to calculate the time evolution from different initial states. To complement our numerical calculations, we apply the method to the Buck–Sukumar model. We find that when the ground-state energy of the model is unbounded and no ground state exists in a certain parameter space, the time evolution of the physical quantities is naturally unstable.     

Single top partner production in the tZ channel at eγ collision in the littlest Higgs model with T-parity

Introducing the top partner is a common way to cancel the largest quadratically divergent contribution to the Higgs mass induced by the top quark. In this work, we study single top partner production in the tZ channel at eγ collision in the littlest Higgs model with T-parity(LHT). Since it is well known that polarized beams can enhance the cross section, we analyze the signal via polarized electron beams,and photon beams. we have selected two decay modes for comparison, based on the leptonic or the hadronic decays of the W and Z from the top partner. We then construct a detailed detector simulation, and choose a set of cuts to enhance signal significance. For mode A(B), the capacity for exclusion in this process at s~(1/2)=3TeV is comparable to the current experimental limits with L=1000(500) fb~(-1). If the integrated luminosity can be increased to 3000 fb~(-1), the top partner mass+mTcan be excluded up to 1350(1440) GeV at 2σ level. We also considered the initial state radiation effect, and find that this effect reduces the excluding ability of the eγ collision on the the top partner mass by approximately 10 GeV. Moreover, the ability to exclude the LHT parameter space at eγ collision complements the existing research.     

Study of semileptonic decay of ${\bar{B}}_{s}^{0} \rightarrow \phi {l}^{+}{l}^{-}$ in QCD sum rule

In this work we study the semileptonic decay of ${\bar{B}}_{s}^{0}\to \phi {l}^{+}{l}^{-}$ (l=e, μ, τ) with the QCD sum rule method. We calculate the ${\bar{B}}_{s}^{0}\to \phi $ translation form factors relevant to this semileptonic decay, then the branching ratios of ${\bar{B}}_{s}^{0}\to \phi {l}^{+}{l}^{-}$ (l=e, μ, τ) decays are calculated with the form factors obtained here. Our result for the branching ratio of ${\bar{B}}_{s}^{0}\to \phi {\mu }^{+}{\mu }^{-}$ agree very well with the recent experimental data. For the unmeasured decay modes such as ${\bar{B}}_{s}^{0}\to \phi {e}^{+}{e}^{-}$ and ${\bar{B}}_{s}^{0}\to \phi {\tau }^{+}{\tau }^{-}$, we give theoretical predictions.     

中国聚变工程实验堆真空室超压保护系统中爆破片的选型与计算

参照相关标准，对聚变装置真空室超压保护系统(VVPSS)中爆破片进行了选型。结合VVPSS的工作要求，完成了爆破片的设计计算，初步得到爆破片直径为882mm，厚度为1mm。利用有限元分析软件对多种型号爆破片进行结构分析比较，最终选用了反拱环向开缝型爆破片。对最终选定的爆破片进行优化设计，使其达到设计要求。     

Theory of particle transport phenomena during fatigue and time-dependent fracture of materials based on mesoscale dynamics and their practical applications

In this work, the mesoscale mechanics of metals, which links their microscopic physics and macroscopic mechanics, was established. For practical applications, the laws for quantitatively predicting life of cycle and time-dependent fracture behavior such as fatigue, hydrogen embrittlement, and high-temperature creep were derived using particle transport phenomena theories such as dislocation group dynamics, hydrogen diffusion, and vacancy diffusion. Furthermore, these concepts were also applied for estimating the degree of viscoelastic deterioration of blood vessel walls, which is dominated by a time-dependent mechanism, and for the diagnosis of aneurysm accompanied by the viscoelastic deterioration of the blood vessel wall. In these theories, new mechanical indexes were derived as dominant factors for predicting the life of fatigue crack growth and the time-dependent fracture of notched specimens of materials such as hydrogen embrittlement and high-temperature creep. Furthermore, as an example of a practical application, these theories were applied to estimate the degree of viscoelastic deterioration and chaotic motions of blood vessel walls, which are closely related to blood vessel diseases such as atherosclerosis and aneurysm. Moreover, new indexes to diagnose them were also proposed for clinical applications.